03-15-2003, 08:33 PM
i set the jumpers to slave and master. the end of the ide cable is connected to the 60gb drive that came with the pc, and the connector of the cable is attatched to the new 120gb drive. when i first turned on the pc, it said "new hardware detected." if i go into the device manager, it is listed there and it says its working properly. according to the booklet, i am suposed to start up the system with the installation floppy in the drive and it will take me through thre steps to setting it up. the last time i tried, it said that there were not any maxtor drive located.
![[Image: soap_256.jpg]](http://forums.colddayinhell.net/files/soap_256.jpg)